Danfoss VLT 5000 Series, Технические данные инструкция

Страница: 27 / 38

VLT
®
5000 INTERBUS
MG.10.O1.02 – VLT is a registered Danfoss trademark
27
Description of selections:
807 PCD size select (PCD SIZE SELECT)
Selection:
✭ 0 Word (0 WORDS) [0]
1 Word (1 WORDS) [1]
2 Word (2 WORDS) [2]
3 Word (3 WORDS) [3]
4 Word (4 WORDS) [4]
5 Word (5 WORDS) [5]
6 Word (6 WORDS) [6]
7 Word (7 WORDS) [7]
Function:
The PCD size select assigns the number of Process
data words, the VLT is using.
Change of parameter 807 is first executed at next
power up, or alarmstop from the INTERBUS Master.
915 PCD config. write (PCD IN WR-)
Selections:
Sub index 1 ([1] 000) Parameter #
Sub index 2 ([2] 000) Parameter #
Sub index 3 ([3] 000) Parameter #
Sub index 4 ([4] 000) Parameter #
Sub index 5 ([5] 000) Parameter #
Sub index 6 ([6] 000) Parameter #
Sub index 7 ([7] 000) Parameter #
Sub index 8 ([8] 000) Parameter #
Function:
Different parameters can be assigned to PCD 1-7 of
the PA data (the number of PCD’s depends on the
setting in parameter 807). The values in PCD 1-7 will
be written to the selected parameters as
data values.
Description of selections:
The order of the subindexes corresponds to the order
of the PCD’s in the PQ + 2, i.e. subindex 1
≈ PCD 3,
subindex 2 ≈ PCD 3 and so on. Each subindex can
hold the number of any of the VLT parameters.
Parameters
916 PCD config. read (PCD IN RD-)
Selections:
Sub index 1 ([1] 000) Parameter #
Sub index 2 ([2] 000) Parameter #
Sub index 3 ([3] 000) Parameter #
Sub index 4 ([4] 000) Parameter #
Sub index 5 ([5] 000) Parameter #
Sub index 6 ([6] 000) Parameter #
Sub index 7 ([7] 000) Parameter #
Sub index 8 ([8] 000) Parameter #
Function:
Different parameters can be assigned to PCD 1-7 of
the PPO’s (the number of PCD’s depends on the
PPO type). PCD 1-7 will hold the actual data value of
the selected parameters.
Description of selections:
The order of the subindexes corresponds to the order
of the PCD’s in the PI + 2, i.e. subindex 1
≈ PCD 3,
subindex 2 ≈ PCD 3 and so on. Each subindex can
hold the number of any of the VLT parameters.
927 Parameter edit
Selections:
Disabled [0]
✭ Enabled [1]
Function:
Editing parameters is possible via either INTERBUS
or the standard RS485 interface, but not both at the
same time. Parameter read is always possible via
the local control panel.
Description of selections:
- Disabled : Parameter edit via INTERBUS is
disabled. Parameter edit via standard RS485 is
possible.
- Enabled : Parameter edit via INTERBUS is
enabled. Parameter edit via standard RS485 port
is blocked