Danfoss PAHT C, Инструкция по установке, эксплуатации и обслуживанию

Страница: 10 / 76

Operation guide | Installation, Operation and Maintenance Manual for PAHT C 2-6.3 pumps
10
180R9316 | AQ176586503002en-000501 | IOM PAHT C 2-6.3 pumps | 01.2022
5.1 Important dimensions
Physical dimensions and connections of the
pump unit are described in appendix 1, Data
sheet .
5.2 Cleanliness
It is very important that the tubes and pipes are
completely clean : no dirt, chips or burrs are
allowed .
Flush all piping before connecting the high-
pressure pump to ensure the system is clean .
Internal surfaces of the piping must not be
corroded . If dirt or rust is not removed, the pump
and the valves can be damaged . In worst case
the pump can be damaged beyond repair!
5.3 Fluid temperature
Before start-up, the fluid and pump housing
temperature must be within the specified
temperature range listed in appendix 1, Data
sheet .
5.4 Electrical data
Check voltage, current frequency and rated
power on the electric motor and VFD settings on
the name plate placed on both the motor and
the VFD .
5.5 Local regulations
Commissioning must always be done in
accordance with valid regulations and local
standards .
5. Installation and
commissioning
Open system design
Closed system design
PI
System
PI
M
1
2
3
4
5 5
7
8
6
Reservoir
PI
System
PI
M
1
2
3
4
6 6 7
8
5
9
12
10
11