MCD 200 Series
MG.17.D3.02 – VLT is a registered Danfoss trademark
27
C
o
m
pon
ent
R
e
pl
acem
e
n
t
Disassembly Sequence 075~110
Step 1.
Remove plastic cover located on the right
hand side of the frot face using the following
procedure.
•
With the MCD 200 unit on its side, locate the
blade of a small flat bladed screw driver
between the lower edge of the plastic and the
metal side plate.
•
Lever the cover off.
Step 2.
Remove plastic lid (complete with door) from
the body of the starter using the following procedure.
•
With the MCD 200 unit on its side, locate the
blade of a small flat bladed screw driver in one
of the four slots (2 each side) on the side of the
lid.
•
While ensuring the screw driver blade is pushed
into the deepest part of the slot (the edge
nearest the front face of the MCD 200) tap the
screw driver so that it is driven into the starter
5-10mm. This will release the clip securing the
lid the upper body moulding.
•
Repeat the above procedure for each of the
four clips.
Step 3.
Remove main Control PCB by lifting it up out
of the unit.
Step 4.
Remove the plastic body moulding using a
flat or Torx screwdriver .
Step 4.
Reassemble the MCD 200 is reverse order.