![background image](http://html1.mh-extra.com/html/danfoss/et4100/et4100_operators-manual_3410471032.webp)
Always use a complete set of equal crimping dies with the same
identification and diameter. One set comprises eight crimping dies
or seven crimping dies and one matching marking die.
Removing the crimping dies
1.
Completely open the crimping tool.
Slowly open the drainage valve hand wheel.
WARNING!
Risk of squeezing!
When the die system closes, there is a risk of getting squeezed
between the dies.
• Only replace the crimping dies when the machine is switched
off.
2.
Manually turn the crimping die to be moved (2) by 30°. This
loosens the retaining bolt in the mounting hole.
3.
Remove the crimping die concerned.
A flat-head screwdriver can be used for assistance. For this pur-
pose, position the flat-head screwdriver between the base die
and crimping die and carefully extract the crimping die.
4.
Remove all eight crimping dies (2) one after the other.
5.4 Setting the forming dimension
The forming dimension (X) must be set specifically for the workpiece.
1.
Read the forming dimension in the forming dimension table of
the system supplier, e.g. Ø 17.4 mm.
Содержание ET4100
