▪
If possible, choose a location where the surfaces nearest the heat pump are soft. Avoid placing the heat pump close to large plas-
tered or tiled areas.
▪
The heat pump is fitted with internal vibration insulation. However, the degree of vibration insulation achieved depends on the
bearing strength of the surface the heat pump stands on. In order to achieve adequate vibration insulation, the heat pump should
be placed on a concrete floor with a thickness of at least 100 mm, or another surface with equivalent characteristics.
▪
In order to minimise noise generation from the heat pump, the sound plate (included) should be fitted when the heat pump has
been put into position.
▪
The heat pump must be level. Make sure to adjust feets in a way that the pump stands steady. If the feet is not adjusted correctly it
could cause some unwanted noise.
3.3
Dismantling the front cover
DHP-M XL and L
1
2
3
1. Turn the two locks on the top panel.
2. Push the front cover out by about 25 cm.
3. Lift the front upwards and lift off.
Installation Guide
DHP-M
Danfoss Heating Solutions
VIJSW102
11
Содержание DHP-M
