Danfoss CF-RU, Инструкция по эксплуатации

Страница: 5 / 36

Instruction CF-RU Repeater Unit
VI.UH.N3.80
Produced by Danfoss Floor Heating Hydronics 01.006
Front Cover – fig. 3
Front cover release
Push Button – fig. 4
Push button (for installation/transmission test)
2. Installation
Note: The Repeater Unit is installed when system enlargement (transmission distance) is
required, or when other system components cannot reach the Master Controller (link test is
unsatisfactory).
Temporarily connect the Repeater Unit to a 230V power supply outlet no further from the
Master Controller than you can operate both products.
Activate Install mode on Master Controller – fig. 4
•
Use the menu selection button to select the Install mode. Install LED
flashes
•
Activate Install mode by pressing OK . Install LED goes ON
Activate Install mode on Repeater Unit
•
Release the front cover, see fig.
•
Press the push button . LED and flicker during communication
Repeater Unit installation status
•
Satisfactory - LED goes OFF
•
Not satisfactory - LED flashes times