4
3060
Installation
Installation
1. Remove lower setting dial. Set all four tappets to top
of upper dial. Unscrew 4BA screw and remove outer
case.
2. Slacken two screws securing plug-in module to
backplate and separate module from backplate by
pulling upwards.
3. Fix backplate to wall (3 hole fixing).
4. Referring to wiring diagrams below and opposite
make electrical connections as shown (as applicable).
The diagrams indicate that terminals 3 and 5 are not
internally connected to the programmer and may
therefore be used as spare wiring terminals if required.
5. Ease of installation can be achieved by the use of the
Danfoss Randall Wiring Centre which is obtainable
from most Builders Merchants and Distributors.
NOTE: If a Wiring Centre is used follow the
installation instructions included with that unit and
not the following wiring diagrams.
6. Secure cable cores under cable clamp.
