Rigging/derigging
2. Attach the first cabinet to the Base plate
1. Place the first cabinet onto the Base plate until the cabinet's
slots fit into the corresponding fixtures of the Base plate.
2. Slightly lower the cabinet until the cabinet's slots have
engaged into the corresponding fixtures of the Base plate.
3. At the rear, release the Locking pin of the Splay link.
4. Fold out the Splay link.
3. Set vertical aiming of the first cabinet
The aiming of the first cabinet can be set to various angles for an
uptilt or downtilt as described in
the Base plate" on page 9.
1. Set the link to the required length ('Standard' for uptilt or
'Extended' for downtilt) and turn the extension tube head
counter clockwise by 90°.
2. Insert the Splay link of the Base plate into the rear rigging
strand of the cabinet and align the hole of the link with the
relevant hole on the strand for uptilt (35° hole) or downtilt
(20° hole).
3. Insert the Locking pin of the cabinet and ensure the pin is fully
inserted and properly locked.
Aiming of the first cabinet
Shown: –10° down tilt
d&b Z5458
AL Base plate Rigging manual 1.1 en
11
