Johnson Controls S1-1FF0602, Руководство по установке

Страница: 1 / 4

Johnson Controls Unitary Products 1199088-UAI-D-1018
ACCESSORY KIT INSTALLATION MANUAL
FILTER FRAME KIT (S1-1FF0601 / S1-1FF0602)
FOR USE WITH MODELS: PCG4 / PCE4 /PHG4 / PHE4 / PCG6 / PCE6 /PHG6 / PHE6
GENERAL INFORMATION
These filter frame kits are for 2 – 5 Ton packaged units. Ensure
that kit received is correct kit for application.The filter frame kit
may be used for downflow or horizontal air flow and with or
without an economizer. The kit accommodates a 1” or 2” thick
air filter.
1. The following list details the parts included in this kit.
Inspect the kit to ensure that all listed parts are included.
2. Layout the frame pieces before assembly to ensure that all
necessary pieces are included.
NORMAL INSTALLATION
Install filter and frame kit as follows:
1. Verify that power to unit is off.
2. Remove filter access panel from unit. See Figures 2 and 9.
3. Place bottom of filter frame in mounting position with larger
end to right toward compressor block off panel. Insert
downward flange into drain pan ledge for support. See Fig-
ure 3.
TABLE 1: Kit Model Numbers
MODEL EQUIPMENT
S1-1FF0601
(Small Base)
AC 2 – 3.5 Ton
HP 2 – 2.5 Ton
S1-1FF0602
(Large Base)
AC 4 – 5 Ton
HP 3 – 5Ton
TABLE 2: Kit Parts (See Figure 1.)
ITEM QUANTY DESCRIPTION
1 1 Top Filter Frame
2 1 Bottom Filter Frame
3 2 Side Rail
4 2 Filter Retainer Bracket
5 8 #10 X 1/2” Hex Head Screw
6 2 #10 X 1/2” self-tapping Hex Head Screw
FIGURE 1: Filter Frame Kit Assembly
SCREW
SCREW
FILTER FRAME
(TOP)
SIDE RAIL
(Wedges
against
rear duct
panel)
FILTER
FRAME
(BOTTOM)
FRAME
ANCHOR
SCREW
HOLE
SIDE RAIL
(Attaches to
compressor
blockoff
panel)
FRAME
ANCHOR
SCREW
HOLE
SCREW
SCREW
A0367-001
FILTER
RETAINER
BRACKET
FILTER
RETAINER
BRACKET
SCREW
SCREW
SCREW
SCREW
NOTICE
If Downflow Economizer is being Installed in the unit, do not
accomplish the Normal Installation procedures. Instead,
accomplish the Secondary Installation procedures at the end
of this document.
NOTICE
The Normal Installation procedures are to be used when a
downflow economizer is not in place. The Normal Installation
procedures can also be used with horizontal flow economiz-
ers, when filter access panel is unobstructed. A 1" or 2" filter
can be used in accordance with the Normal Installation.
FIGURE 2: Filter Access Panel
FIGURE 3: Filter Frame in Mounting Position.
FILTER
ACCESS
PANEL
A0382-001
A0383-001
FILTER FRAME
(BOTTOM)