2.1. Product description
V7P/V10P are passive 3-way loudspeakers housing two 10" LF
drivers, one horn-loaded 8" MF driver and a 1.4" HF compression
driver with a rotatable CD horn producing a nominal dispersion (h
x v) of 75° x 40° (V7P) and 110° x 40° (V10P), respectively.
All components are arranged symmetrically around the center axis
of the cabinet to produce a perfect symmetrical dispersion pattern.
This setup allows for a crossover design with a well defined
overlap of adjacent frequency bands resulting in a very consistent
and accurate vertical dispersion. Due to the dipolar arrangement
of the low drivers, broadband vertical dispersion control is
maintained down to approximately 350 Hz – an outstanding
feature for a passive 3-way system.
The frequency response extends from 59 Hz to above 18 kHz.
The cabinets are constructed from marine plywood and have an
impact and weather protected PCP (Polyurea Cabinet Protection)
finish. The top and bottom panels incorporate a handle each. The
front of the loudspeaker cabinet is protected by a rigid metal grill
backed by an acoustically transparent foam.
The cabinets are fitted with three types of rigging devices:
–
Two M10 threaded inserts on the top and bottom panels each
to accept either the Z5383 VP Mounting bracket, the Z5384
VP Flying adapter or the Z5388 VP Horizontal bracket.
–
Three additional combined sockets
[A], one in the top panel
and two at the rear of the cabinet that accept either:
– the Q9032 Safety eye bolt M10 to apply a independent
secondary safety device.
– the Z5049 Flying pin 8 mm to support single cabinets or to
secure the aiming of an array.
Intended use of the Z5049 Flying pin
WARNING!
Potential risk of personal injury and/or
damage to material!
The Z5049 Flying pin 8 mm is designed and intended for static
loads only. Therefore please observe the following:
–
The Flying pin must not be used to attach a secondary safety
device.
–
Ensure the Flying pin is securely locked before lifting any load.
Proceed as follows:
1. Press the button to
release the locking mechanism ([r]
).
2. Fully insert the Flying pin into the respective socket.
3. Release the button to
lock the pin ([l]
).
4. Recheck the Flying pin is securely locked by briefly pulling the
Flying pin towards you.
V7P loudspeaker
2. V7P/V10P loudspeaker
d&b V7P/V10P Manual 1.3 en
5
