T10
Fig. 1: T10 loudspeaker
Fig. 2: T10 Horn and lens
in line source setup
Fig. 3: T10 Horn and lens
in point source setup
The T10 is a very compact loudspeaker system which can be used both
as a line array and as a high directivity point source speaker. For these
applications the T10 cabinet provides two different dispersion
characteristics which can be swapped over without any tools.
The core of the design is a unique combination of a rotatable
waveguide with horn and an acoustic lens. The horn natively provides a
vertical line source with 90° horizontal dispersion. The lens is part of the
front grill and widens the HF dispersion in line array mode to 105°.
When used upright as a point source, the lens curves the wavefront of
the line source providing a 90° x 35° dispersion pattern.
The T10 is a two way design employing dual 6.5” drivers, a 1.4” exit
compression driver and a passive crossover network. The low drivers
are positioned in a dipolar arrangement providing an exceptional
dispersion control towards low frequencies. Its frequency response
extends from 68 Hz to above 18 kHz.
The T10 enclosure is constructed from polyurethane integral hard foam
with an impact and weather resistant black paint finish. The cabinet
shape allows the system to be set up as a single unit in upright
orientation or as a line array in user defined vertical configurations. The
front of the loudspeaker cabinet is protected by a rigid metal grill in
front of an acoustically transparent foam.
NOTICE:
Only operate T10 loudspeakers with a correctly
configured d&b amplifier, otherwise there is a risk of
damaging the loudspeaker components.
T-Series rigging components and arrays
For point source applications the T10 is fitted with six threaded inserts to
connect to different rigging accessories like Z5371 T Flying bracket,
Z5372 T Horizontal bracket, Z5354 E8/E12 Flying adapter or
Z5020/25 Flying adapter 02/03.
When applied as a line array, cabinets are mechanically connected
using the rigging strands on both sides of the cabinet front and a
central strand at the rear of the cabinet. All necessary rigging
components are mounted to the cabinet and are folded or slide out
when needed. Splay angles between adjacent cabinets can be set in the
range from 0° to 15°.
A detailed description of the T-Series rigging components is given in the
T-Series Rigging manual which is provided with the Z5370 T Flying
frame.
T10 line arrays of up to 3 cabinets can be supported with the
Z5373 T Cluster bracket which allows an easy aiming of the array
either flown or mounted on a high-stand.
A detailed description of planning and designing T-Series arrays is
given in the technical information "TI 385 J, Q and T-Series system
design, d&b ArrayCalc" which is also provided with the T Flying frame.
The d&b ArrayCalc array calculator can be downloaded from the d&b
website at
www.dbaudio.com
.
T10 Manual
(1.0 EN)
Page 4 of 10
Содержание T10
Страница 1: ...T10 Manual 1 0 EN...
