Emergency situation
If the system for some reason, is not possible to operate by the remote, you can always use your handle for manual operation by
following this procerure:
The spring holding the adaptor must be removed as shown in fig. (N1). Take away the adaptor from the toothed wheel fig. (N2). This
makes it possible to use your handle. Observe: The adaptor can be a little tight to remove if legs are loaded (legs are down).
Manual operation must NEVER be performed when adaptor is insertet. Using handle or other tool when adaptor is inserted will damage
the gear of the motor. Waranty void.
Re-insert the adaptor
Please press carefully the adaptor into the tooth wheel fig (N2). Supporting the bracket by holding with fingers fig. (N4). To let the
adaptor pass freely over the spindle hex-bolt, turning the spindle a little is sometimes necessary. Fasten the spring as shown i fig. (N3)
ensuring the spring are firmly in the spring groove. Wrong insertion of the adaptor or spring can cause permanent damage of the
gear. Warant void.
Possible reasons of unintented function (stop working)
The system measure the load when the spindles are turning. If the load are too high, even before the legs touch the ground, it is most
likely that the spindles are in poor conditions. Remove the adaptors, check by manual turning and make necessary service to the legs.
Cleaning
away
carefully the old grease and use thin PTFE oil for long and smooth operation.
Check the battery and fuse condition.
If one or more steady legs are not moving down as intented, please see page 6. «stucked stady leg»
Emergency
Fig. N1
Fig. N2
Fig. N3
Fig. N4
Site 7/8
Copyright: www.dancar.dk
toothed wheel
Distance between
bracket and
adaptor edge.
Spring groove
Spring
Adaptor
