DANA SPICER AXLE 212, Руководство по обслуживанию, Страница: 90 / 176

90
ASSEMBLY
Dana Holding Corporation ASM-0025E - 212 Axle Service Manual
ASSEMBLY
FIGURE 9: Install thrust levers (12) and (13), then install the
U-joint (14).
For details, see DOUBLE U-JOINT p. 29.
FIGURE 10: Apply Loctite 270 to the threaded portion of the
pins (11) and fit them onto the piston (10).
Block them: torque wrench setting 30 - 35 N·m.
FIGURE 11: Re-install the piston (10) and the braking disks
(9).
For details, see CHECKING WEAR AND REPLACING THE
BRAKING DISCS p. 19.
12 13
14
11
10
9
10
FIGURE 12: Install the arms (8) into the main body; check flat-
ness and block arms following the appropriate procedures il-
lustrated in section MECHANICAL PARKING BRAKE p. 87
and HYDRAULIC NEGATIVE BRAKE p. 151.
FIGURE 13: Install the bushing (6) complete with o-ring (7)
and block it with screws (5). Tighten screws with a torque
wrench setting of 23.8 - 26.2 N·m.
FIGURE 14: Install in sequence the lower o-ring (4), the lever
(3) and the washer (2) with the relative o-ring (4).
Block with screw (1) and tighten using a torque wrench set-
ting of 23.8 - 26.2 N·m.
Refer and keep to the positions marked during disassembly.
5
6
1
2
3
CAUTION