Dan Dugan Sound Design E-1, Руководство пользователя

Страница: 17 / 52

Dugan Models E-1 and E-1A User Guide Installation and Configuration
17
Insert
1. Check the insert jack wiring on your mixing board.
If they are 1/4-in TRS jacks (wired tip = send, ring = return), use TRS-TRS insert ca-
bles to connect the Model E-1A. Other configurations require special cables. The
Model E-1A is wired as follows: tip = input, ring = output.
2. Patch the audio channels in the insert loop (send-return) of each console input strip.
This is the normal way to connect the Model E-1A using a mic-level signal.
Figure 3-3
Analog insert (left) and line level (right) block diagrams
Line Level
Use split insert cables. The receiver output is wired to the tip of the TRS plug. The
console’s line input connector is fed from the TRS plug’s ring.
Digital I/O
1. Move the
ANALOG–DIGITAL
switch to the
DIGITAL
(down) position.
This switches the input to the
DIGITAL IN
connectors. Linking is still possible and
the analog outputs remain active.
2. Use two ADAT (Toslink) cables to connect the console’s ADAT interface to the
Model E-1A’s
AUD IN
and
AUD OUT
connectors.
Figure 3-4
ADAT audio connectors