5
INSTALLATION
• Make sure the main breaker is turned off. Installation must be carried out by a
qualified person in accordance with standards applicable in the country where
the equipment is to be installed.
• Place template against the wall at desired height (see mounting height recommendation)
and mark location of (4) mounting holes and the wire service entry.
NOTE
Colours of live and neutral wires depend on
voltage of supply service.
5. Connect supply wires to terminal block:
CONNECTIONS:
A.
Connect live wire (coloured red or brown) to the
terminal block marked ”L”
B.
Connect neutral wire (coloured blue) to terminal blcok
marked ”N”
C.
Connect the ground wire (coloured green and yellow)
to the terminal block marked ” ”
1. Remove the two screws in the lower area of
the unit and remove the casing from its base.
3. Attach the hand dryer base plate to the wall
with the screws supplied with the unit.
4. Insert the power cord through the inlet hole.
Fasten with the retaining clip.
2. Place the mounting
template on the wall at the
desired location. Drill (4) holes
as indicated.
A ( 1 : 1 )
A
L
N
