5
INSTALLATION
1: Remove the two screws in the lower
area of the unit and remove the casing
from its base.
5: Replace the casing and fasten with two
screws in the lower area
3: Connect supply wires to terminal block
4: Attach mounting plate
securely with four screws
2: Insert the power cord through the inlet
hole.
Connections:
A. Connect LIVE to terminal “L”
B. Connect NEUTRAL to terminal “N”
C. Connect GROUND to terminal “ “
Make sure the main breaker is turned off. Installation must be carried out by a
qualified person in accordance with standards applicable in the country where
the equipment is to be installed.
Place template against the wall at desired height (see mounting height recommendations)
and mark location of (4) mounting holes and the wire service entry.
Note
: If several products are installed in close proximity to each other, the minimum
distance between the products should be 610 mm from the centerline of each product.
