Kabinet
Nylon-b¯sning til hul til kabelindgang
TrÊkaflastningsb¯jle
KlemmerÊkke
Jordskrue
St¯ddÊmper
BlÊserhus, top
Gummipakning til blÊserhus (stor)
Motor, 700 W
Gummipakning til blÊserhus (lille)
Varmelegeme, 900 W
UdblÊsningsstuds
Beslag til sensor
Sensor
OphÊng til blÊserhus
Bagplade
Potentiometer
Beslag til potentiometer
Timer
BlÊserhus, bund
Kabinetskrue (2 stk.)
Unbrakon¯gle til kabinetskruer
12
13
14
15
16
17
18
19
20
21
22
RESERVEDELE, TURBO DESIGN
8
9
No. Description
1
Housing
2
Nylon bushing for cable inlet hole
3
Cable clamp
4
Terminal block
5
Earthing screw
6
Shock absorber
7
Blower housing - upper part
8
Rubber gasket for blower housing
(large)
9
Motor, 700W
10 Rubber gasket for blower housing
(small)
11 Heating element, 900W
12 Outlet branch
TROUBLESHOOTING AND CORRECTIVE ACTIONS
PARTS LIST
SYMPTOM
CORRECTIVE ACTION: NEW HAND DRYER
The dryer does not run
•
Check power supply to the product and ensure the
connections at the terminal block are made properly.
The dryer cycles by itself and
runs constantly
•
Make sure nothing is obstructing the IR-sensor activa-
tion area.
•
If problem persists, check the recommended installa-
tion height.
The dryer is very loud and
does not run for a complete
cycle
•
Ensure power supply is correct
•
If the timer is damaged, replace both timer and sensor
Hand dryer runs randomly
and stops before the cycle is
finished
•
Check timer and sensor. Replace if required.
The hand dryer runs, but the
airspeed is low
•
Ensure the voltage is correct.
•
Check setting of potentiomenter for air speed adjust-
ment (see page 7).
SYMPTOM
CORRECTIVE ACTION: USED HAND DRYER
Hand dryer does not start
•
Check power supply to the product and ensure the
connections at the terminal block are made properly.
IR-sensor only detects motion
when hands are placed really
close to the hand dryer
•
Make sure nothing is obstructing the IR-sensor.
•
Clean sensor. If the problem persists, disconnect the-
power and remove the cabinet, taking suitable precau-
tion to avoid schock hazard.
•
Carefully adjust sensor range (see paragraph on this
subject).
•
If the problem persists, replace sensor and timer.
The dryer gets hot, but there is
no air stream
•
Disconnect the power. Remove the cover and disas-
semble the blower/fan unit.
The dryer blows only cold air
during a full cycle
•
Disconnect the power.
•
Remove the cover and disassemble the blower/fan
unit.
•
Check the heating element thermostate for open
circuit.
•
Check the heating element for defects. Replace defect
heating element.
Hand dryer does not run
smoothly
•
Check carbon brushes. Replace if they are worn or
damaged. If no faults are detected, replace motor.
No. Description
13 Gasket for sensor
14 Sensor
15 Bracket for blower housing
16 Backplate
17 Potentiometer
18 Bracket for potentiometer
19 Timer
20 Blower housing – lower part
21 Housing screws (2 pcs.)
22 Allen key for housing screws
