Damon Astoria 2006, Руководство пользователя

Страница: 88 / 112

Troubleshooting
No AC power to unit.
Check circuit breakers at power center. The 120 Volt circuit breaker may be off
or tripped
.
Have a dealer check that there is power to the shoreline receptacle.
Electric step does not operate.
Verify that step switch is in ON position.
Check battery voltage. Recharge or replace as needed.
Check door switch alignment. Realign or repair if necessary.
Check 25 Amp fuse in the battery control center.
Check step frame for damage or misalignment. Replace if necessary.
Lubricate step assembly with a lithium spray grease if necessary.
Step operates intermittently.
Check door switch alignment. Realign if necessary.
Check step frame for damage or insuffi cient lubrication. Replace or lubricate if
necessary.
Furnace does not ignite and/or cycles frequently.
Check that LP gas tank is full.
Remove any obstruction over furnace exhaust.
Inspect exhaust tube for any obstructions.
Check fuse in fuse panel and replace if necessary.
Make sure that return air grill is unobstructed.
Remove anything that is stored in furnace compartment that could block air fl ow.
Check that heat outlet registers are open and that register openings are unob-
structed.
Contact a Damon dealer if the problem persists.
Make sure that 12 Volt power is present.
Point the remote at the air conditioner to ignite the furnace.
Furnace does not light and fan does not run.
Replace fuse with one of the same ampere rating.
Turn thermostat and furnace gas control valve off and contact
your dealer or an authorized service center. DO NOT attempt to
repair or adjust the furnace yourself.
FURNACE
ELECTRICAL POWER
ELECTRIC STEP