Dalsa Spyder 3 GigE SG-10-01k40-00-R, Руководство пользователя

Страница: 26 / 121

Spyder 3 GigE User Manual
03-032-10158-09 DALSA
26
!
2.4.2 Power Connector
Figure 9: Hirose 6-pin Circular Male—Power Connector
Hirose 6-pin Circular Male
5
4
6
2
3
1
Mat ing Par t: HIRO SE
HR10A-7P-6S
The camera requires a single voltage input (+12 to +15V). The camera meets all
performance specifications using standard switching power supplies, although well-
regulated linear supplies provide optimum performance.
WARNING: When setting up the camera’s power supplies follow these guidelines:
•
Apply the appropriate voltages
•
Protect the camera with a
fast-blow fuse
between power supply and camera.
•
Do not use the shield on a multi-conductor cable for ground.
•
Keep leads as short as possible to reduce voltage drop.
•
Use high-quality
linear
supplies to minimize noise.
Note: Camera performance specifications are not guaranteed if your power supply does not meet
these requirements.
DALSA offers a power supply with attached 6’ power cable that meets the Spyder 3 GigE
camera’s requirements, but it should not be considered the only choice. Many high
quality supplies are available from other vendors. Visit the
11H
www.dalsa.com Web site for a
list of companies that make power supplies that meet the camera’s requirements. The
companies listed should not be considered the only choices.
2.4.3 GPIO Connector
The GPIO connector is used to receive or control external signals. For example, the GPIO
connector can be used to receive EXSYNC, PRIN (pixel reset), and direction signals.
Figure 10: GPIO Connector and Pin Numbers
1
5
11
15
Table 5: GPIO Connector Pinout
Pin Signal Description
1 INPUT_ 0+ LVDS/TTL format (positive)
Table 4: Hirose Pin Description
Pin Description Pin Description
1 Min +12 to Max +15V 4 GND
2 Min +12 to Max +15V 5 GND
3 Min +12 to Max +15V 6 GND