UK
DE
DK
CN
JP
FR
DALI A/S www.dali-speakers.com
7
They can be used with spikes or rubber bumpers under the speakers (see Figure
4D/E). Be careful not to over tighten the spike locking nuts.
Spikes or rubber bumpers can improve the sound quality. You can try both to hear
what gives the best sound quality in your setup. Please be aware, that spikes may
damage the floor, if it is not protected by e.g. coins under the spikes.
3.2 DALI OBERON 1 & 3
The speaker can be positioned on a stand/shelf or for OBERON 1 hung on a wall
using the integrated wall bracket. If positioned on a stand or shelf, the enclosed
rubber bumpers can be mounted under the speaker for stable and vibration free
positioning (see Figure 4A).
If hanging OBERON 1 on a wall, mount the bumpers on the rear edges of the
speakers (see Figure 4B). The speaker is hung on a wall using one screw mounted
in the wall. The screw must fit the wall bracket on the rear side of the speaker
(see Figure 4C).
Both speakers should ideally be positioned, so that the height of the tweeter is
approximately at ear height when seated in your favourite listening position.
3.3 DALI OBERON ON-WALL
DALI OBERON ON-WALL is optimized for wall-mounting (see Figure 7), should
ideally be positioned, so that the height of the tweeter is approximately at ear
height when seated in your favourite listening position. There should be at least 10
cm (4”) to any surface underneath the speaker.
3.4 DALI OBERON VOKAL & GRAND VOKAL
OBERON VOKAL & GRAND VOKAL are dedicated centre channel speakers and
have been specially designed to be positioned close to the large surface of the TV
screen. You can place them above or below the screen, on a stand or on a shelf.
We recommend fitting the enclosed bumpers to ensure a stable, vibration-free
setup (see Figure 4F).
4 . 0 C O N N E C T I O N
Correct, tight connections to your amplifier are extremely important for your
listening experience. Always use cables of the same type and length for left and
right channels. We recommend using special speaker cables from DALI, available
from your dealer.
Connection in correct phase is a detail that is often ignored. The red (+) terminal
of the amplifier must be connected to the red (+) terminal of the loudspeaker. The
black (-) terminal of the amplifier must be connected to the black (-) terminal of the
loudspeaker (see figure 5). Even a single loudspeaker connected out-of-phase in
a stereo or surround installation will make the bass weaker and the stereo image
unfocused.
For the optimal listening experience, the right loudspeaker (as seen from the
listening position) must be connected to the amplifier output terminals marked
