11
10
Installation
Please study and follow the safety
guidelines found on page 2 and 4 of this
manual!
DALI Helicon IW 200 Phantom must be
installed by a trained professional to
ensure that all safety requirements are
met to prevent it from falling, etc.
The following tools and items are necessary for
proper installation:
• Spirit level and tape measure
• Pencil and saw or knife
• 3 mm Allen wrench
(included with loudspeaker)
• Wire cutter and cutting nippers for
mounting of steel wire
• Drill and bit
• Steel wire
• Hook and rawlplugs of the correct sizes
• Paint (if needed)
• Protective template (if needed)
• Compressed air (if needed)
When the correct placement has been found, tape
the mounting template to the surface perfectly
level. Outline the cut-out area with a pencil.
Remove the template and drill holes for insertion
of saw or knife. Saw/cut carefully along the line
marked in pencil.
"%7!2%/&).34!,,!4)/.3
0!30±).34!,,!4)/.%2
NORMAL
LOW FREQ LEVEL
ENHANCED
Installation
A steel drop wire must be firmly attached
between a solid support in the house (ceiling
beam, wall stud, etc.) and the eyehook on the
DALI Helicon IW 200 Phantom in order to hold
the speaker in case of a fall. This is particularly
important for ceiling mounting, where a falling
speaker can be life-threatening!
Connect cable to the terminals - being careful
to connect the amplifier’s red (+) terminal to the
loudspeaker’s red (+) terminal and the amplifi-
er’s black (-) terminal to the loudspeaker’s black
(-) terminal.
Loudspeaker cable must not hang loose from
the terminals. It must be securely fastened with
cable ties or by other means inside the wall. If left
unsupported, cable can gradually come loose,
creating a poor electrical connection between
wire and terminals.
Turn on the system and listen to the loudspeak-
ers before final mounting to make sure that all
connections are correct.
Insert the speaker in the wall opening and
tighten the 6 screws in the loudspeaker brack-
ets with the enclosed Allen wrench so that the
speaker is firmly mounted in place. Be careful to
avoid over-tightening the screws and shredding
the thread.
-!8#-v$2/0
34%%,7)2%
#%,,).'7!,,
hCM
hCM
hCM
