7
6
Mounting Template
The enclosed template can be used to initially visualise how your speakers should
be mounted. Then, tape the template perfectly level at the selected mounting
position, so that you can mark the necessary opening.
Helicon IW 200 Phantom
DALI Helicon IW 200 Phantom incorporates dog-
leg brackets for wall or ceiling mounting. The
brackets attach the loudspeaker firmly to the
rear of the surface on which it is mounted. They
extend out at a 90 degree angle when the screws
are tightened. The screws should be tightened
so that the loudspeaker sits securely in place
- but be careful not to tighten them too much.
If you need to remove the loudspeaker, loosen
the screws approximately 5 to 10 turns counter-
clockwise and the brackets will loosen their grip.
Do not unscrew more than 5 to 10 turns or the
bracket may fall off the screws.
DALI Helicon IW 200 Phantom must be fitted
with a drop wire to prevent the speaker from fall-
ing in the event of fire, earthquake, etc. To pre-
vent injury or damage from a fall, fit a steel wire
or other non-flammable connection between a
solid support in the house (ceiling beam, wall
stud, etc.) and the eyehook on the Helicon IW
200 Phantom as shown.
Connect cables so that the loudspeaker is in cor-
rect phase. The red (+) loudspeaker terminal must
be connected to the red (+) amplifier terminal. The
black (-) loudspeaker terminal must be connected
to the black (-) amplifier terminal.
Remove insulation so that approx. ½” of bare
wire is exposed. Press the top of the terminal
down and insert the bare wire into the open-
ing. When the wire is fully in place with no loose
strands exposed, release the terminal. The cable
is now connected.
-!8#-v$2/0
34%%,7)2%
#%,,).'7!,,
Skabelonen skal være 100% vandret før skæring
NORMAL
LOW FREQ LEVEL
ENHANCED
