DALBO MAXICUT, Руководство пользователя, Страница: 23 / 30

MAXICUT
Side 23
Mounting
1.
Fit new gaskets (pos. 2+4+7+8+9) in upper part and collar shoe. Remember to
check gaskets are facing the right way.
2. Lubricate thread in upper part (pos. 3) with oil.
3. Fit upper part (pos. 3) on ram shaft.
4. Fit collar shoe (pos. 4) and screw on lock nut, secure with Loctite. Ensure that
thread is absolutely clean and free of oil or other impurities before applying
Loctite. Do not fill with oil for 12 hours after use of Loctite.
5. Lubricate outer collar shoe gasket in contact with cylinder tube and inside of
cylinder tube with oil, push ram into centre position.
6. Fit upper part onto cylinder tube and tighten.
7. Fit cylinder (see "Replacing extend cylinder for retracting side sections").
Replacing raise/lower cylinder
Fig. 10
Extend roller and relieve pressure on
raise/lower cylinder (A).
1.
Disconnect hoses from cylinder
2. Support cylinder
3. Remove split pins in pins, remove pins
4. Remove cylinder
5. Fit new or repaired cylinder
Activate cylinders after assembly. Activate cylinders both ways, retract-
ing/extending fully in both outer positions. This is necessary to bleed the system
and cylinder.
Ensure no personnel are within the extension radius of the side sections.
A