dalap HW 6206, Инструкция по эксплуатации

Страница: 5 / 48

plug in,this function can be used in any models.
2. Press “
”
button one time, all lights and LED display are
closed ,only “Power” light on.In this condition, either control panel or
remote control can not operate the appliance for any function.
3. Press “ ” button again, all lights are on and both control panel and
remote control are use to succeed.
CONTROL PANEL VIEW:
REMOTE CONTROL VIEW:
1. Remote control, please use Lithium battery CR2025 3V.
2. The remote control power button is labeled as such
1 .” ON/OFF ” Main power button
2 .“ 24H ” Setting timer from 1-24 hours
3 .“ MODE ” COLD,WARM,HOT 3 setting for selection
4.“Swing” Louver swing up and down
5.“ LOCK ” Child-Lock function for heater
6.“ AUTO ” Window Open Function
7.“Tem.” Display room temperature
8.“ Delay ” Set the open and closed time of heater
9.“ W.Timer ” Set the timer of one week
10 .“ + ” Increase
11 .“ - ” Decrease
12 .“ Set ” Set real time
OVERHEAT PROTECTION
This heater is protected with an overheat protection that switches off the
appliance automatically in case of overheating. For example: due to the
total or partial obstruction of the vents. In this case, unplug the appliance,
wait about 30 seconds for it to cool and remove the object which is
obstructing the vents. Then switch it back on as described above. The
appliance should now operate normally. If the problem persist, please
contact Customer Service for assistance.
CLEANING & MAINTENANCE
•
Before undertaking any cleaning or maintenance on the appliance,
disconnect it from the power supply.
•
For cleaning it is recommended to use a soft moist rag and neutral
detergent. Do not use an abrasive cloth or devices which could affect
the appearance of the appliance. Check that the hot air outlet and the
ventilation inlet are free of dust and dirt.
During cleaning, be careful not to touch the heating elements.
•
To open the filter on the back for cleaning, press the top of plastic net
at back.
•
In case of breakdown and/or poor functioning of the appliance,
disconnect the appliance from the power supply and contact an
authorised repairer.