Daktronics TI-2031, Руководство пользователя

Страница: 8 / 24

Mechanical & Electrical Installation
4
Flush Mount Method
Reference Drawings:
System Riser- Remote Radio Receiver.............................................................. DWG-260394
Installation DWG; TI-2031/3031 Locker Room Clock ..................................... DWG-1064515
The flush mount cabinet mounts between two 2x4 studs and uses the flush mount rear
panel.
1� Drill holes in the wall and install anchors or screws at the locations shown in DWG-
1064515 . The customer is responsible for providing mounting anchors or screws.
2� Rough out the power supply and signal recess behind cabinet mounting location as
depicted in DWG-1064515 .
3� Install a 120 VAC, 15 Amp electrical outlet on the stud behind the drywall behind the
opening for the clock. This will allow the wallpack transformer to be plugged in and
be out of the way when the clock is installed in the wall.
4� Route the signal cable to the clock mounting location and allow it to extend at least
12" (305 mm) beyond the wall.
5� Plug the wallpack transformer into the outlet.
6� Mount the flush-style rear cabinet panel and tighten the anchor screws as needed.
7� Connect the signal wire to plug P-1388 signal terminal on the left side of the display
(when viewed from the rear). Connect the red signal wire to the positive (+) jack
labeled CL-IN and the white signal wire to the negative (-) jack labeled CL-IN .
Note: For installations with radio control from the All Sport console, refer to DWG-
260934 .
8� Plug the wall pack transformer into the power jack located below the signal terminal.
9� Line up and mate the rear and front cabinet pieces. Attach the pieces together with
included screws.