Daktronics TI-2031, Руководство пользователя

Страница: 7 / 24

Mechanical & Electrical Installation
3
2 Mechanical & Electrical Installation
The TI-2031 and TI-3031 locker room clocks are connected to the signal from the main
scoreboard in the facility and will display the same time that is shown on the scoreboard.
There are two primary methods of installing these locker room clocks:
1) surface mounted on the wall with mounting screws or anchors, or
2) flush mounted in the wall between standard spaced 16" (406 mm) studs.
Surface Mount Method
Reference Drawings:
System Riser- Remote Radio Receiver.............................................................. DWG-260394
Installation DWG; TI-2031/3031 Locker Room Clock ..................................... DWG-1064515
The surface mount cabinet mounts centered over an electrical outlet and uses the deep
rear mounting panel.
1� Drill holes in the wall and install anchors or screws at the locations shown in DWG-
1064515 . The customer is responsible for providing mounting anchors or screws.
2� Install a 120 VAC, 15 Amp electrical outlet or use an existing outlet that is located
where the display will be installed. The outlet should be positioned behind the
clock cabinet so that the wallpack transformer fits in the recessed area of the rear
mounting panel.
3� Mount the rear panel on anchor screws and tighten.
4� Route the signal cable to the clock mounting location and allow it to extend at least
12" (305 mm) beyond the wall.
5� Connect the signal wire to plug P-1388 signal terminal on the left side of the display
(when viewed from the rear). Connect the red signal wire to the positive (+) jack
labeled CL-IN and the white signal wire to the negative (-) jack labeled CL-IN .
Note: For installations with radio control from the All Sport console, refer to DWG-
260934 .
6� Plug the wallpack transformer into the power jack located below the signal terminal,
and then plug the wallpack transformer into the electrical outlet.
7� Line up and mate the rear and front cabinet pieces. Attach the pieces together with
included screws.