Daktronics ST-2373 Series, Руководство пользователя

Страница: 6 / 46

Introduction
2
Resources
Figure 2 illustrates a Daktronics drawing label.
This manual refers to drawings by listing the last
set of digits. In the example, the drawing would
be referred to as DWG-1007804 . All references to
drawing numbers, appendices, figures, or other
manuals are presented in bold typeface. Any
drawings referenced in a particular section are
listed at the beginning of it as shown below:
Reference Drawing:
System Riser Diagram ....................................................................................... DWG-1007804
Daktronics identifies manuals by the DD or ED number located on the cover page.
Listed below are drawing types commonly used by Daktronics, along with the information
each is likely to provide. All drawings referenced in this manual are found in Appendix A .
• Schematic Drawings: describe internal power and signal wiring as well as
interconnections between display sections; may also include driver addressing
information
• Shop Drawings: describe mounting methods to structural elements, access method
(front or rear), and power and signal entrance points
• System Riser Diagrams: describe power/signal connections between components
and the control location; may also include control room layout and schematic
• Final Assembly Drawings: describe internal display component locations and
detailed product appearance with part numbers and quantities
Ensure all applicable materials have been gathered before beginning the installation.
Contact a Daktronics sales coordinator or project manager.
Daktronics Nomenclature
Most display components have a white label that lists the part
number ( Figure 3 ). Part numbers will also appear on certain drawings.
If a display component is not found in the Replacement Parts (p�17) ,
use the label to order a replacement. Refer to Section 5: Daktronics
Exchange and Repair & Return Programs (p�18) if replacing or
repairing any display component.
Main Component Labels
Part Type Part Number
Individual circuit board 0P-XXXX-XXXX
Assembly; a collection of parts 0A-XXXX-XXXX
Wire or cable W-XXXX
Fuse F-XXXX
Transformer T-XXXX
Metal part 0M-XXXXXXX
Fabricated metal assembly 0S-XXXXXX
Specially ordered part PR-XXXXX-X
Drawing Number
Figure 2: Drawing Label
0P-1127-0024
SN: 2465
02/19/12 Rev. 1
Figure 3: Part Label
Accessory Labels
Component Label
Termination block for
power or signal cable
TBXX
Grounding point EXX
Power or signal jack JXX
Power or signal plug for
the opposite jack
PXX