Daktronics ST-2373 Series, Руководство пользователя

Страница: 10 / 46

Mechanical Installation
6
4� Latch all three latches on the left table to the right table (as viewed from the rear).
Refer to Figure 8 for illustrations of each latch properly connected.
Flip the hook end of the latch into the receiving slot on the adjacent table. Ensure
the tables are seated completely together to avoid over-pulling the latch and flip the
latch down into the locked position.
5� Repeat Steps 1–4 for all remaining tables.
Adjusting Latch Tension
The tension of the latches is pre-set at the factory. When engaged, the latches should
create a snug fit. If there is a noticeable gap between the tables or if it is difficult to clasp
the latches shut, adjust the tension by following the steps below and referring to Figure 9 .
1� Use a 5/16" wrench to loosen the nut holding the metal hook in place.
2� Turn the metal hook clockwise to tighten the latch or counterclockwise to loosen the
latch.
3� Ensure the metal hook is pointing straight downward and then tighten the nut.
Front of caster base Cable tray Rear of caster base
Figure 8: Latching Sections Together
Figure 9: Adjusting Latch Tension