Daktronics Sportsound SSR-200, Руководство по эксплуатации

Страница: 16 / 38

12 Setup & Operation
Basic instructions are described below. For more information about mixer operation, refer to the
Soundcraft
EFX EPM User Guide .
• Ensure all source equipment is turned on and operational
(refer to appropriate pages).
• For each input channel (source) in use, verify the following
adjustments (
Figure 19
):
– INSERT jack has nothing plugged into it
– GAIN knob is set to an appropriate level
– PAN knob is set to the center position
– MUTE button is not depressed
• Depress the PFL button to listen to each input channel
without interrupting the main mix.
With an input source playing or while speaking into the
microphone, adjust the gain knob and channel fader until the
output meter shows 0 dB ( Figure 20 ). Release the PFL button, and
repeat this step for all other channels in use.
Note: The PEAK LED indicates that the signal is close to
distorting (clipping).
• Slowly bring up the channel and master volume faders until the
output meter displays 0 dB or adequate volume is achieved. Red
LEDs indicate clipping. Also ensure the
2 TRACK MONITOR
button is not depressed.
REMEMBER: Bad input = bad output. No adjustment on the mixer can
make a poor source sound better. For best results, be sure to use high-
quality audio files from your MP3 player or laptop, and set the device to
near full volume.
Note: Ensure the mixer is outputting PHANTOM POWER ( Figure 21 )
when using a first generation Announcer's Console (
Figure 22
) or
when balanced condenser microphones are plugged into the mixer inputs.
figure 19:
Channel Adjustments
figure 20:
Output Meter
figure 21: Phantom Power
figure 22:
1st Gen Announcer's Interface