Daktronics Sportsound SSR-200, Руководство по эксплуатации

Страница: 13 / 38

Setup & Operation 9
Section 3: Setup & Operation
3.1 Setup
Before Beginning: Place the rack on a flat, sturdy surface. Remove the cover pieces by twisting the knobs
away from each other, and set them aside. Accessories are located in a separate case. Refer to the steps below
and Figure 17 .
1.
Announcer's Interface setup is described below. For more information, refer also to the quick guide
( DD3083838 ) shipped with the device.
a. Connect the 2' (610 mm) XLR cable between the microphone and the MIC 1 INPUT jack.
b. Connect headphones to the 1/4" or 1/8" jack.
c. Connect the provided 12 VAC wallpack transformer to the power input jack, and then plug
the other end into a standard 120 VAC outlet. Use the tab above the power jack as a strain
relief for the power cord.
2. Connect the 15' (4.6 m) XLR cable from MIC 1 & AUX 1 on the announcer’s interface to MIC 1 &
AUX 1 on the rear of the rack.
3. Connect the 25' (7.6 m) XLR cable between the AUDIO OUT jack on the rear of the rack and the
SYSTEM AUDIO
jack on the bottom of the fiber box. If there is no fiber box, the cable will typically
connect to a wall plate junction box instead.
4. Connect one end of the 5' (1.5 m) XLR cable to the LTIBLOX Laptop Interface and the other end to an
open MIC input on the mixer. The 3.5 mm plug may be connected to the headphone jack of a laptop
or MP3 player.
5.
Locate the 3-prong power cord and plug into a standard 120 VAC outlet. Ensure the fiber box
(if included) also has power.
6. Turn on the power strip.
7.
Switch the
AUDIO SIGNAL
to
ON
.
Follow the above steps in reverse order to power down the system. Place all accessories
in the storage case.
Note:
Ensure all antennas are perpendicular to the rack and angled outward at ~45°.
Alternately, coaxial cable from the high gain antenna kit may be connected into the
WRX A
and
WRX B
jacks on the rear of the rack. The antennas should be located
within 50' (15.2 m) of the rack, using desktop stands or mounted to the ceiling. Refer
to the
Shure
®
Model PA805 Directional Antenna User Guide
for more information.
The optional Hearing Assist System universal antenna kit (
Figure 16
) may be located
up to 10' (3 m) away from the rack, mounted to the ceiling or a wall. Ensure there is
enough room to fully extend the antennas and that the coaxial cable is plugged into
the WTX2 jack on the rear of the rack. Refer to the LA-122 Universal Antenna Kit
User’s Manual
for more information.
figure 16: ADA
Universal Antenna Kit