Daktronics PC-2002, Руководство пользователя

Страница: 9 / 34

Electrical Installation
5
Wireless Signal Connection
The PC-2002 is capable of being controlled via wireless signal. The wireless radio system
requires a Daktronics All Sport
®
scoring console or OmniSport
®
2000 timing console
equipped with radio transmitter as well as a radio receiver mounted inside the display.
The optional radio receiver is installed on the right side of the display cabinet (as viewed
from the front).
1� Power off the display.
2� Turn the display around so that you are looking at the rear.
3� Using a Phillips screwdriver, remove the 10 outer screws to separate the front and rear
panels of the display.
4� CAREFULLY lay the rear panel flat to expose the internal components.
5� Disconnect the 5-pin connector from the J2 RADIO JACK on the left side of the driver
printed circuit board (PCB).
Note: With a radio receiver installed, it will not be possible to use the SIGNAL IN or
SIGNAL OUT terminal blocks.
6� Connect the 6-pin power/signal cable from the radio receiver unit ( A ) into the mating
6-pin radio adapter cable ( B ). Refer to Figure 6 .
Figure 6: Radio Power/Signal Cable and Adapter
7� Connect the 5-pin end of the radio adapter cable ( C ) into the J2 RADIO JACK . Refer
to Figure 7 .
Figure 7: Radio Connection
8� Remove the plastic strips from the adhesive-backed hook-and-loop fasteners on the
back of the radio receiver unit, and stick the unit to the inside left side of the rear
panel.