Daktronics Galaxy AF-3190 Series, Руководство пользователя

Страница: 39 / 97

Ethernet (Wire)
The controller has a default IP address of 172.16.192.25. Use this address to connect
to the primary display, and then it can be changed to an address specified by the
network administrator.
Electrical surges may enter over the cable; it is the
customer’s responsibility to protect their network.
An Ethernet controlled display, requires the use of an RJ45 cable from the network
to the display with the following connections:
1. Connect one end of the RJ45 cable to a network hub or switch.
2. From the network connection, cable is run to the Ethernet surge card in
the display.
3. The cable from the Ethernet hub to the surge board in the display must
be routed through conduit.
Do not run signal and power through the
same conduit. Refer to
Figure 31
for system layout.
4. Note: Ethernet signal into the display does not allow for the normal
RS422 output signal to a second primary display. This includes both or
either the use of an interconnect cable or separate wiring between
displays.
Figure 31: Ethernet Display Layout
An Ethernet controlled display, uses a Cat-5 (W-1467) or Cat-5E (W-1384) cable
routed through separate conduit to the
display. The maximum distance is 330
feet (100 meters).
Figure 32: Ethernet Signal Connection
1. Connect from the Ethernet port
on the computer into the
Ethernet wall jack.
2. Run the cable through separate
conduit into the display and
connect to J1 on the Ethernet
surge board (0P-1229-2012) as
shown in
Figure 32
.
3. A five-foot RJ45 cable (W-
1506) connects for the J2 output
on the surge card to the
Ethernet port on the controller.
Electrical Installation
3-17