Mechanical Installation
9
Clamping Angles
Mounting hardware includes rear clamping angles;
1
/
2
-13 x 24" threaded rods; and
1
/
2
" nuts,
flat washers, and lock washers. Refer to
Drawing A-1052388
in
Appendix B
.
Note:
The threaded rods do not pass through the beams; they run along both sides.
1.
Screw a threaded rod into each of the spring nuts as far as it will go.
2.
Position the scoreboard at the front of the beams, and lift it to the desired height.
3.
Slide clamping angles over the ends of the rods and loosely install the washers and nuts.
4.
Make final adjustments in the positioning of the ad panel to ensure it is flush and
level, and firmly tighten all of the
1
/
2
" hex nuts.
2.4 Scoreboard Protective Devices
Daktronics makes optional protective devices, including screens and netting, to help prevent
damage to the scoreboard due to normal ball impacts.
Note:
Some users install devices to protect the scoreboard from projectiles. Scoreboard
protection devices not provided by Daktronics must be approved by Daktronics prior to
installation. Failure to follow this approval procedure will void the scoreboard warranty.
Figure 11:
Ad Panel Mounting with Clamping Angles, Side View
