Daktronics 65 Series, Руководство по установке

Страница: 14 / 29

Section Splicing
10
10� Ensure the display sections align from front to back.
11� Starting at one end of the display, place the flat splice
plates over the bolts and place a nut and washer on
each bolt. Refer to Figure 13 .
Note: Evenly distribute the splice plates along the
back of the display. Ensure there is a flat splice
plate near each end of the display. Refer to
Figure 14 .
12� Use an impact wrench, the torque stick, and a
11
/
16
″
socket to tighten all of the nuts on the mounting plate
to 75 ft-lb.
13� Loosen the nuts that
hold the vertical
splice tube, located at
the end of the display,
in place. Refer to
Figure 15 .
14� Slide the vertical splice
tube so it is split evenly
between the top and
bottom display
sections.
15� Tighten the vertical
splice tube nuts to
secure the splice tube
in place to 75 foot-
pounds.
16� Repeat Steps 15 - 16
for all vertical splice
tubes.
17� Slide the border splice
plates, shown in
Figure 17 , and covers,
shown in Figure 18 ,
when equipped, into
place and attach with
supplied nuts and Tek
screws.
Figure 13: Attaching Splice Plate
Figure 14: Splice Plate Installation Locations
Figure 15: Aligning and Installing
the Vertical Splice Tubes
Top
Section
Bottom
Section
Splice
Plate
Bolt
Nut
Washer
Display Face
Figure 16: Installed Flat Splice
Plate
Figure 17: Attached Border
Splice Plate
Figure 18: Attaching Vertical
Splice Cover