3
MAN#650446
Setting the warning limit:
The low and high warning limits can be set to different values for each sensor. A push
button switch connected to the SW terminal is used for setting the warning limit. The switch
should provide a momentary ground to the SW terminal. The procedure for setting the
warning limit is as follows:
1. Hold the switch while you turn the key on. The display should light up and show “WARNING”
“SETUP”.
2. Release the switch. The display should show “FOUND x SENDERS” with ‘x’ indicating the
number of senders detected. This number should match the number of senders connected to the
BIM-19-1. Only senders that are connected can have their warning points set. (if 0 is shown,
check the BIM and sender connections and then momentarily press the switch)
3. The display will show the first sender label and its ID #.
4. Each time the switch is momentarily pressed it will go to the next sender.
5. When the desired sender is shown, press and hold the switch. When the lower section of the
display blanks, release the switch.
6. The display will now show “Warning Lo” and the current low warning point (0 – 252).
7. Each time the switch is momentarily pressed the low warning point will increase.
8. When the desired low warning point is displayed, press and hold the switch. When the text
blanks, release the switch.
9. The display will now show “Warning Hi” and the current high warning point (48 – 300).
10. Each time the switch is momentarily pressed the high warning point will increase.
11. When the desired high warning point is displayed, press and hold the switch. When the text
blanks, release the switch.
12.
The display will now go back to the sender selection screen in step 4. You can select another
sender to set or turn the key off to exit setup.
