Dakota Digital BIM-01-2, Руководство пользователя

Страница: 5 / 7

MAN #650500F
BIM setup:
Enable or disable engine indicator status from the BIM-01-2
•
Hold the switch on the BIM-01-2 case while turning the key on. The BIM display will show the current revision
code while this is held.
•
Release the switch.
•
Press and release the switch until the display shows
“  ” (engine). Press and hold to enter this menu.
•
When you see
“  ” on the display release the switch.
•
The display will show the current state or the engine indicator enable

(enable) or

(disable).
•
Press and release the switch to change the state.
•
To save setting press and hold the switch until you see
“  ” on the display then release the switch.
• The display will show “  ”. Press and hold the switch to exit setup or press and release to choose another menu
option.
Enable or disable gear position output from the BIM-01-2
•
Hold the switch on the BIM-01-2 case while turning the key on. The BIM display will show the current revision
code while this is held.
•
Release the switch.
•
Press and release the switch until the display shows
“  ” (gear position). Press and hold to enter this menu.
•
When you see
“  ” on the display release the switch.
•
The display will show the current state of the gear position

(enable) or

(disable).
•
Press and release the switch to change the state
•
To save setting press and hold the switch until you see
“  ” on the display then release the switch.
• The display will show “  ”. Press and hold the switch to exit setup or press and release to choose another menu
option.
Enable or disable vacuum/boost output from the BIM-01-2
**Note: This reading is taken from the MAP sensor. A functional MAP sensor is required for an accurate reading. Vacuum
reading is in inHg and boost is in PSI.
•
Hold the switch on the BIM-01-2 case while turning the key on. The BIM display will show the current revision
code while this is held.
•
Release the switch.
•
Press and release the switch until the display shows
“  ” (boost). Press and hold to enter this menu.
•
When you see
“  ” on the display release the switch.
•
The display will show the current state for boost enable

(enable) or

(disable).
•
If turning

ensure the BIM is connected to a VHX/HDX/VFD/RTX system because the BIM will automatically
choose a BIM channel on the system.
•
Press and release the switch to change the state.
•
To save setting press and hold the switch until you see
“  ” on the display then release the switch.
• The display will show “  ”. Press and hold the switch to exit setup or press and release to choose another menu
option.
Enable RPM signal for Ford Performance control pack/Coyote Engines
**Note: It is recommended to use the default setting
(

)
. Only enable this setting if your RPM signal is not functioning.
•
Hold the switch on the BIM-01-2 case while turning the key on. The BIM display will show the current revision
code while this is held.
•
Release the switch.
•
Press and release the switch until the display shows
“  ” (TACH). Press and hold to enter this menu.
•
When you see
“  ” on the display release the switch.
•
The display will show the current state

(standard) or

(Ford).
•
Press and release the switch to change the state.
•
To save setting press and hold the switch until you see
“  ” on the display then release the switch.
• The display will show “  ”. Press and hold the switch to exit setup or press and release to choose another menu
option.