Dakota Digital 3X Series, Инструкция по установке и эксплуатации

Страница: 27 / 36

MAN 650067:G 27
ODOMETER PRESET MENU
The control box will allow you to set the odometer reading to match your current odometer
reading, ONE time within the first 100 miles. Once the odometer has more than 100 miles,
this menu option will no longer be displayed. Make sure you have correctly selected the
units to be either MPH or km/h and calibrated your speedometer first. The odometer will
be set in the selected units. Once you have preset the miles, you cannot change it again
without sending to the factory.
WARNING!!: This only allows setting odometer to the nearest mile. Do not use tenths!
For example a mileage of 65432.1 should be set to “ 065432 ” using this method. If the
tenths digit is used, the odometer will read 10 times too high.
•
Press and hold SW1 while turning the key on.
•
Release the switch and then press and release SW1 to get to the “ -ODOM ” setup menu.
•
Press and hold the switch until “ - ” “ -ODOM ” is displayed to enter the odometer setup menu,
then release SW1. The current miles will be displayed on the odometer with the left most
digit flashing.
•
Press and release SW1 to increment the digit. Press and hold the switch to move to the next
digit to the right.
•
Continue until the right most digit has been set. Press and hold the switch and the speed
display will show “ nO ”
•
If the value is incorrect, press and hold the switch while “ nO ” is displayed to go back and
change the odometer miles or turn the key off to cancel any changes.
•
If the value is correct, press and release the switch to change to speed display to “ YES ”.
•
Press and hold the switch while “ YES ” is displayed to save the current odometer reading and
return to the setup menus.