6.
Mounting the transmitter:
The transmitter can be mounted to any wall using the mount-
ing bracket. (figure 4)
The mounting bracket is located on the back of the UT-3000
and can be removed by simply sliding it off. Position the brack-
et were you would like it and place two screws in the holes
provided. To place the UT-3000 back simply slide it over the
bracket.
Coding the receiver:
1. Open the receiver case by inserting a small screwdriver into one of the pry notches on
the side of the case (refer to receiver manual) and gently lift off the front cover.
3. Locate the eight dip switches on the receiver and make sure they are set identically to
dip switches 1-8 on the transmitter.
Note: If more than one transmitter is used with the receiver, the first eight dip switches of all
transmitters must match the eight dip switches of the receiver.
Note: Whenever a change is made to the time jumper or the dip switches, the receiver must be
turned OFF and then back ON to operate properly.
Figure 4
