4. After you choose a tune, activate the wireless probe transmitter by pressing the
“A”
button on the transmitter board (SEE DIAGRAM NEXT PAGE). You should hear a short
beep from the receiver.
5. Press the volume button again until you hear the sound you want for a
vehicle leaving.
6. After choosing a tune, activate the wireless probe transmitter by pressing the
“B”
button on the transmitter board. You should hear a short beep from the receiver.
7. If you are programming more than one transmitter, repeat steps 3-6.
*Up to 16 zones can
be coded to one receiver (each “A” or “B” is considered one zone).
8. After your transmitter(s) are coded, press and hold the
MODE
button until the LEDs stop
flashing (about three seconds).
9. To test the tune, activate the wireless probe transmitter by pressing the
“A” or “B” button again.
You should hear the selected tune and see the lights flash
on your receiver.
5
NOTE: If you only want a signal when a vehicle enters,
program only the “A” button. If you only want a signal
when a vehicle exits, program only the “B” button.
