IMPORTANT - CE & SAFETY REQUIREMENTS
Product must be mounted inside a suitable enclosure providing environmental protection to IP65 or greater.
To maintain CE EMC requirements, input wires must be less than 30 metres.
The product contains no serviceable parts, or internal adjustments. No attempt must be made to repair this product. Faulty units must be returned to supplier for repair.
This product must be installed by a qualified person. All electrical wiring must be carried out in accordance with the appropriate regulations for the place of installation.
Before attempting any electrical connection work, please ensure all supplies are switched off.
ABSOLUTE MAXIMUM CONDITIONS ( To exceed may cause damage to the unit) :-
Supply Voltage
± 30 V dc (Protected for over voltage and reverse connection)
Current with over voltage
± 100 mA
Input Voltage
± 3 V between any terminals
Ambient
Temperature
(-30 to 70) °C Humidity (10 to 95) % RH (Non condensing)
1605P USER GUIDE
SMART DIN RAIL MOUNTED TRANSMITTER INPUT PT100
TWO WIRE (4 to 20) mA
Every effort has been taken to ensure the accuracy of this document, however we do not accept responsibility for damage, injury, loss or expense resulting from errors and omissions, and we reserve the right of amendment without notice.
Important - Please read this document before any installing.
Please refer to the product data sheet for full specification, available to download at www.
ditel.es
Please inspect the packaging and instrument thoroughly for any signs of transit damage. If the instrument has been damaged, please notify your supplier immediately.
The following parameter can be configured by simply entering as prompted by the
software package.
RTD INPUT TYPE ( Pt100,Ni100, Ni120, CU53, CU100 )
· Low range
· High range
· Units
(°C, °F)
· Burnout (direction of output current on sensor burnout)
Factory default:
RTD
= Pt100
IEC
= 003851
Low Range
= 0
High Range
= 100
Units
= °C
Burnout
= UPSCALE
1605 P
USB SPEEDLINK SOFTWARE
USB CABLE
Download @
www.status.co.uk
COMPUTER
IMPORTANT - The
KOS
1605P can be configured whilst connected and powered, but a portable battery powered computer must be used to avoid the
effects of ground loops.
PRODUCT SPECIFICATION
RECEIVE AND UNPACKING
CONFIGURATION
RTD Input
2 Wire (4 to 20) mA Output
KOS1605P
Vs
Loop
Load
USB
+
-
+
-
www.
Tel : +
s
@
MT-KOS1605
P
_EN_
20190606
User Guide
307277
2
3
According to 2012/19/EU Directive, You cannot dispose of it at the end
of its lifetime as unsorted municipal waste.
You can give it back, without any cost, to the place where it was
adquired to proceed to its controlled treatment and recycling.
