4/29/03
Model Trademaster
Section I -
5
KEEP ALL SAFETY GUARDS IN PLACE.
Be sure that all guards are in working order,
positioned properly and are aligned and adjusted correctly.
CHECK EXPOSURE.
Adjust the machine for minimum exposure of cutting tool
necessary to perform each operation.
GROUND ALL TOOLS.
Make sure wiring codes and recommended electrical
connections are followed and that the machine is properly grounded.
KEEP ALL CHILDERN AND VISITORS AWAY.
All visitors should be kept a safe
distance from the work area. Don’t let visitors come into contact with machine or power
cord. Any person visiting the work area should wear appropriate protective devices for
eyes, face, ear, respiratory and body coverage as indicated for the operation or
environment.
STAY ALERT. WATCH WHAT YOU ARE DOING. USE COMMON SENSE AT ALL
TIMES. NEVER OPERATE ANY TOOL OR PIECE OF MACHINERY WHILE TIRED
OR UNDER THE INFLUENCE OF DRUGS, ALCOHOL OR MEDICATION.
UNPACKING AND CHECKING CONTENTS
Carefully unpack and discard crating material. Unbolt machine from pallet and lift off.
(You can lift your Trademaster saw by the upper portion of the saw using a lift truck.)
Only lift in this manner with the door OPEN or damage may result.
Un-tape all doors and remove the cardboard box from the bottom of the saw base.
Install 10-pound weight on the outside counterweight bar.
Install 40-pound weight using the bolt provided on the arm inside the lower cabinet.
Install the foot pedal and speed selector knob.
Remove the protective coating from the table using a water base grease remover.
CAUTION: Gasoline, naphtha, kerosene lacquer thinner, mineral spirits and other
related solvents are highly flammable. Wipe thoroughly with a clean, dry cloth.
The lock for the table travel is found under the table on the table rail. Be sure to unlock
it before attempting to move the table.
WARNING: For your own safety, do not connect your saw to the power source
until the machine is completely assembled.
WARNING: This machine has been shipped with the table locked. Before
operation the lock clamp on the right hand table rail must be loosened.
