Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
977102-1
8
REV112019
•
Adjust the table or depth stop to avoiding drilling into the table, shut off the power.
Remove the drill bit or cutting tool, and clean the table before leaving the machine.
•
Do not operate until completely assembled and installed according to the instructions.
•
If any part of your drill press is malfunctioning, has been damaged, or broken do not
operate until the part is properly repaired or replaced.
•
Lockout the motor switch when leaving the drill pre
ss. Don’t perform layout, assembly, or
setup work on the table while the cutting tools rotating.
Voltage Warning:
•
Before connecting the machine to a power source know your incoming voltage.
•
At power source with voltage greater than that specified for the machine can result in
serious injury to the user and can damage the machine.
•
Using a power source with voltage less than that of the machines rating can damage the
motor and other components.
•
If you are unsure of the voltage rating do not use the machine.
SAFETY FEATURES
