Dake SLTC93, Инструкция по установке, использованию и обслуживанию

Страница: 17 / 52

SLTC97 minimum distance from the cook top:
650mm
Secure the wall brackets to the wall, by using the
anchors and screws supplied with the appliance
(FIG. 6A).
Hook the hood to the wall brackets previously fi-
xed (FIG. 6).
SLTC93 - SLTC94 - SLTC95 - SLTC97 - SLTC103
Tighten the two screws into the wall bracket (fig.
7A), which are necessary to make the applian-
ce adhere to the wall; then check that the hood
is perfectly flush with wall, otherwise act on the
screws shown in fig. 7B, as follows tighten the
screw if you need to lift the corresponding side,
or unscrew it in case you need to reduce the
height.
Carry out the electrical connection, by using the
appropriate power cord.
Only for SLTC93 and SLTC94 models: open the
front panel by rotating the lower part upwards, as
shown in (fig. 8 and fig. 9).
Remove the grease filter in order to reach the ap-
pliance inner side. The grease filter is removed
by following the instructions given in the mainte-
nance section.
Definitively secure the product to the wall by
using the screws provided, as shown in fig. 10.
Refit the grease filter and close the front panel.
SL96
Remove the grease filter , as shown in the main-
tenance section.
Tighten the two screws into the wall bracket (fig.
11A), which are necessary to make the applian-
ce adhere to the wall; then check that the hood
is perfectly flush, otherwise act on the screws
shown in fig. 11B , as follows: tighten the screw
if you need to lift the corresponding side, or un-
screw it in case you need to reduce the height.
Carry out the electrical connection by using the
appropriate power cord.
Definitively secure the product to the wall by
using the screws provided, as shown in fig. 10.
Refit the grease filter: see the maintenance sec-
tion.
Suctioning mode (top air out-let).
Secure the pipe support bracket (fig. 12) to the
wall and/or the ceiling , by using the anchors and
screws provided, in a position corresponding to
the centre of the hood.
Connect the motor air out-let flange to the exhaust
hole , by using a suitable pipe.
Place the two decorative pipes on the hood
exhaust body ; lift the inner pipe as long as it rea-
ches the bracket; then secure it by using the no.
2 self-threaded screws provided .
The suctioning version, with top air out-let, is
not available in the SL96 model.
Suctioning mode (rear air out-let).
You will need to rotate the suction motor, as
shown in the installation section and in fig. 3 and
4, in order to direct the motor air out-let towards
the appliance rear side .
Fit the air out-let grid into place on top of the
hood (fig. 13). The use of steel decorative pipes
is not necessary .
In SLTC97 model, it is always necessary to
use the steel decorative pipes, even if the rear
air out-let is used.
Filtering mode.
Fit the air out-let grid into place on top of the
hood (fig. 13). The use of steel decorative pipes
is not necessary.
In the filtering version, a charcoal filter shall also
be used, as shown in the maintenance section,
according to the model.
In SLTC97 model, it is always necessary to
use the steel decorative pipes, even in the fil-
tering version.
17