Dake Atmos, Инструкция по установке, использованию и обслуживанию

Страница: 21 / 24

21
for 2 seconds. When Leds light on, press buttons:
(within 5 seconds). Leds flashing 6 times indicate
the procedure is completed.
WARNING! This operation deletes permanen-
tly the preset codes.
Emergency button:
In the event that the radio control does not work,
use the emergency button to switch the appliance
off. After any necessary repairs have been perfor-
med, reset the emergency button.
WARNING
The battery should be replaced every year to
guarantee the optimal range of the transmitter.
To replace the exhausted battery, take the pla-
stic lid off, remove the battery and replace it
with a new one, observing the correct battery
polarities.
Used batteries should be discarded in special
collection bins.
The below product:
RC001 Radio Controll
complies with the specifications set out in the
Directive RED 2014/53/EU.
WARNING
Any adjustments or modifications which have
not been expressly approved by the holder of
the legal conformity certificate may invalidate
the user’s rights relating to the operation of
the device.
Rev. 0 26/08/14
The products are endowed with an electronic de-
vice which allows the automatic switching off after
4 hours working from the last operation.
An accurate maintenance guarantees good fun-
ctioning and long-lasting performance. Special
care needs to be taken with the grease filter:
to access the filter, proceed as described in the
PANEL OPENING chapter.
Remove the grease filter, using the special handle.
To refit the grease filter after cleaning, carry out
the same operation in reverse order.
To remove the carbon filter, if fitted, follow the
same steps as for the grease filter.
The carbon filter is located immediately above
the grease filter.
Tepid water and neutral detergents are recom-
mended to clean the appliance, while abrasive
products should be avoided.
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a simi-
larly qualified person in order to avoid a hazard.
* Replacement of the LED bar:
Using an appropriate tool, remove the LED bar
from its seat (refer to Fig. 15), disconnect it elec-
tro nically throught the appropriate connector
then re place it with a LED bar with same cha-
racteristics.
* Replacement of the LED bar GLASS PANEL
To remove the led bar , it is recommended to re-
move the steel bar as shown in Fig. 16.
Replace the led bar with one of the same cha-
racteristics.
Refit the steel bar.
MAINTENANCE