7
HOOKUP INSTRUCTIONS FOR
TOOL TO AIR SUPPLY
When not in use, the tool should be disconnected and
stored in the storage case in a warm and dry place. When
tool will not be in use for an extended period, apply a thin
coat of the lubricant to the steel parts to avoid rust.
Do not store the tool in a cold weather environment.
For better performance, install a 3/8 inch quick plug(1/4
inch NPT threads) with an inside diameter of 0.315 inch
(8mm) on the nailer and a 3/8 inch quick coupler on the air
hose.
Load fasteners into nailer.
Point the nailer in a safe direction while attaching to air
hose.
Nailer is ready for use. You may need to adjust outlet
pressure to achieve proper fastener depth.
RECOMMENDED
HOOKUP
MINIMUM COMPONENTS
REQUIRED FOR HOOKUP
4.
5.
6.
Air compressor:
The air compressor must be able to
maintain a minimum of 60PSI when the nailer is being
used. An inadequate air supply can cause a loss of power
and inconsistent driving.
Pressure regulator: A pressure regulator is required to
control the operating pressure of the nailer between 60PSI
and 100PSI .
Always use air supply hoses with a
minimum working pressure rating equal to or greater than
the pressure from the power source, or 150PSI, whichever
is greater. Use 1/4 inch air hose for runs up to 50 feet. Use
3/8 inch air hose for 50 feet, run or longer.
Air supply hose:
Keep out of reach of children and personnel unfamiliar with
tool operation.
Lock the storage area. Tools are dangerous
in the hands of personnel unfamiliar with the tool.
STORAGE
WARNING
With ON/OFF switch in OFF position, plug compressor
into electrical outlet.
Close pressure regulator by turning all the way to the
left. Turn compressor ON and let it pump all the way up
to automatic shut-off pressure.
Attach air hose to regulator outlet. Adjust pressure
regulator by turning to the right so that outlet pressure is
between 60PSI to 100PSI.
1.
2.
3.
When cleaning a tool be careful not to disassembly any
portion of the tool since internal components may be
misplaced or safety components may be improperly
mounted.
Certain cleaning agents such as gasoline, carbon
tetrachloride, ammonia. etc. may damage plastic parts and
o-rings.
CLEANING
WARNING
Do not attempt to clean by inserting pointed objects through
openings.
.
Sharp edges may damage internal components
causing a serious hazard.
Ventilation openings, the work contact element, and the
trigger must be kept clean and free of foreign matter
Periodically clean the tool with compressed air.
Clean the magazine. Remove metal or wooden chips which
may have accumulated in the magazine. Periodically clean
magazine with compressed air.
WARNING
