28
GB
Configuration
Remote control configuration is used to customise the
control keys according to user habits.
1)
Choose the remote control key to be customised.
2)
Choose a command number (2 or 3 digits) from the
table overleaf, to match the command to be customised.
3)
Configure as described in the sequence below:
Each command number digit corresponds to a certain
number of times that the remote control is pressed.
A programming error is indicated by the red LED
indicator lamp flashing 3 times during or at the end
of configuration. When this happens programming
should be carried out again from the start.
Approx.
2 s
LED
indicator
lamp OFF
LED
Indicator
lamp ON
Configuration
sequence
Approx.
5 s
Approx. 10 s
Approx. 2 s
Approx. 10 s
1)
To
start
the sequence,
simultaneously
press the
ON
and
OFF
keys
2)
Press once
on the key to be
customised
OFF, ON, P1, P2
3)
Press and hold
the
selected key
until the LED
indicator lamp goes
out temporarily
4)
Press the key
as many times
as the
1
st
digit
in the command
number
5)
Press the key
as many times
as the
2
nd
digit
in the command
number
6)
Press the key
as many times
as the
3
rd
digit
in the command
number
7)
To
end
the
sequence,
simultaneously
press the
ON
and
OFF
keys
The LED
indicator lamp
comes on
permanently =
configuration
correct.
Approx.
2 s
{
{
{
{
{
Содержание 612-21X
Страница 32: ...32 ...
Страница 36: ...803402 G 03 06 ...
