DAITEM 171-21X, Руководство по установке

Страница: 4 / 8

4
Checking configuration: check the alarm level by selecting the Parameter N° and checking the number of corresponding
flashes.
Start Press 4 times to select
the alarm level
Press once to
accept selection
End 2 flashes confirm
that the device is set
for a prealert
4 2
4. Configuration
IMPORTANT: The casing must be open when configuring the detector.
• Detection parameter selection:
• Follow the configuration sequence described below:
Choice Parameter Parameter Technical data
of function n° value
Detection sensitivity 1 1 1 st edge triggering: not recommended for detector 171-21X/175-21X
2
2 nd edge triggering (factory setting):
recommended for interior using detector 171-21X/175-21X
Alarm level 4 1 Intrusion (factory setting)
2 Prealert
3 Deterrence
4 Warning
Freeze detection 7 1
Disabled (factory setting)
setting 3 Enabled
Configuration example: setting the detector for an alarm level when a full prealert is triggered: Parameter n° 4, Parameter
value 2.
To start the sequence
press and hold the
button until the LED
indicator lamp goes out
Press 1, 4 or 7 times
depending on the
required parameter
number
Press and hold
until the LED
indicator lamp
briefly goes out
Press 1 to 4 times
depending on the
required parameter
value
To end the sequence
press and hold the button
until the LED indicator
lamp goes out
1, 4 or 7 1 to 4
about
5 sec.
about 10 sec. about 2 sec. about 10 sec.
LED indicator
lamp lit =
correct
configuration
Start Press 4 times to select
the alarm level
Press once to
accept selection
Press 2 times
to select
the prealert level
Press and hold until the
LED goes out to finish
4 2