DAITEM 171-21X, Руководство по установке

Страница: 7 / 8

7
6. Maintenance
6.1 Battery low indication
6.2 Changing the battery
IMPORTANT: if the test LED indicator lamp no longer lights up, the lithium battery should be replaced.
The control panel indicates when the infrared detector’s battery is low.
To check whether there is a problem with the detector battery, press on the detector’s test button.
To change the battery:
1. Switch the control panel to installation mode and ask the user to press:
then
The detector’s configuration is saved when the battery is changed.
2. Open the detector casing (see § on Opening).
3. Unclip the lithium battery pack.
4. Wait 2 min. before replacing the flat lithium battery.
5. Close the detector.
6. Switch the control panel back to user mode . Press:
“beep, installation
mode”
“beep, date,
time, off”
master code engineer installer code
engineer installer code
IMPORTANT: Pull on the tab to remove the lithium battery.
7. Technical data
Specifications Infrared motion detector
Infrared detection • 171-21X/175-21X: 12 m, 90°, motion detector
• 172-21X: 22 m, 12°, corridor detector
• 173-21X: 12 m, 8°, curtain detector
Fixing methods • on a swivel bracket
• flat against the wall
• in a corner
Use inside
Power supply 2 x 3.6 V - 2 Ah BatLi25 lithium battery
Battery life 5 years in normal conditions of use
Average humidity rate 5% to 75% without condensation at 25°C
Radio links TwinBand ® 400/800 MHz
Test button battery and detection
LED indicator lamp 1
Operating temperature -10° C to +55° C
Protection mechanism against opening and removal (unless swivel bracket mounted)
Degrees of mechanical protection IP 31/ IK 04
Dimensions without swivel bracket 58 x 102 x 57 mm
Weight 115 g (with battery, swivel bracket and base)
• The lithium battery pack must be replaced by the same type of pack with the same technical characteristics
(BATLi25, 2 x 3.6 V – 2 Ah).
• We advise you to use the DAITEM BatLi25 pack available in the catalogue in order to guarantee individual
safety and equipment reliability.
• Dispose of the waste lithium power pack in an appropriate recycling bin.
Li