DAITEM 171-21X, Руководство по установке

Страница: 5 / 8

5
5. Installing the detector
5.1 Choosing the best place
IMPORTANT: make sure there is a distance of at least 2 meters between each product, except between two detectors.
The motion detector must be placed:
• inside the building,
• 2.20 m above ground level
• at right angles to the entrances to be protected (interior
detection works best when the intruder walks across the
detector’s fields-of-view),
• directed towards the inside of the room to be protected,
• in such a way that the area it protects does not overlap
with that of another motion detector.
The motion detector must not be placed:
• in an area likely to receive direct sunlight or a very powerful
light source,
• opposite or above a source of heat,
• outside or in a breezy place,
• directly on to a metal wall or close to sources of
interference (electricity meters, etc.) or ventilation such as
air-conditioning grilles.
5.2 Fixing method
IMPORTANT: for reasons of security and to ensure long battery life, installation of the anti-tamper pin is compulsory. In case of
omission or incorrect insertion of the pin, the detector LED indicator lamp flashes continuously when the detector is fitted to its
bracket.
The detector can be fixed to a wall
in 3 ways:
• on a swivel bracket,
• flat against the wall,
• in a corner.
There is an anti-tamper pin for each
type of fixing method:
• swivel bracket: pin n° 0,
• flat: pin n° 1,
• in a corner: n° 2.
RIGHT
WRONG
RIGHT
WRONG
Back plate cover
Order in which to assemble parts
Selection of pins
Screw
+ tightening
washer
Swivel
Long screw
Pin n° 1
Pin n° 2
Back plate
Base
Pin n° 0
for swivel bracket
fixing (factory-
mounted pin)
Pictogram
Pozidriv 1 Pozidriv 2
IMPORTANT: for swivel bracket fixing, pin n° 0 is already factory-positioned inside the detector.
• Fixing the detector on a swivel bracket
1. Hold the back plate against the wall in the desired position and
mark where to drill the holes.
2. Drill the holes in the wall.
3. Insert the long screw via the back plate and fasten the plate to the
wall.
4. Put the back plate cover in place.
5. Assemble both parts of the swivel.
6. Insert the mounted swivel into the long screw.
7. Position the base of the motion detector (a picture of a man shows
the top of the detector).
8. Tighten the screws lightly in order to be able to adjust the direction
of the motion detector.
9. Place the motion detector on its base and turn it so that it is facing
the right way.