48
49
GB
GB
Preparation
Face plate
The test button and LED indicator
lamp are used to:
• check normal operation of the
detection head,
• change the detector to test mode
(radio link test).
Inside view
The programming key and LED indi-
cator lamp (accessible when the
casing is open) are used to:
• check the battery,
• programme detector/control panel
recognition,
• programme the detector and dou-
ble-check the settings,
• check the radio link.
test
button
red LED
indicator lamp
for smoke
detection
battery
red LED
indicator lamp
for programming
programming
key
sounder
Programming
Programming enables the smoke
detector to be recognised by the
control panel.
Connect the battery.
To programme the smoke detector, the
control panel must be in installation
mode. If it is not, press:
2
✱
then
10 s max.
1)
Press
*
then
#
on the
control panel keypad
2)
Press & hold the
“programming”
key for 10 sec.
until the control panel responds
• Carry out the programming sequence described below:
)
)
)
)
)
then press:
3
engineer installer code
master code
“beep, fire detector n° X”
803416_C_Det_Fum_150-21X 11/04/05 9:57 Page 48
